Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, i am trying to create a L2TP VPN connection for user to remote connection back to office. can i set ip unnumbered GigabitEthernet5 ?can I set in this way? or I have to create the loopback?i am not sure which ip route i should create. please advis...
Hi, I am trying to configure L2TP remote connection back to office, however when I try to add the crypto map to my interface i get "Cannot apply empty map to interface" what am I missing?R1(config)#intR1(config)#interface gig5R1(config-if)#cryR1(conf...
Hi, I am trying to setup a configuration for remote access VPN I am unable to use router#(config)crypto isakmpI only got below insteadR1#crypto ?key Key related commands.pki Public Key components https://learningnetwork.cisco.com/s/question/0D53i000...
Hi, Hope this can help someone. To connect local network storage, mine is DS1817+. Create port forward and connect thru internet.Do reply here if you have better or easier configuration! =D Configuration on Cisco Router:ip nat inside source static ud...
hi,dyndns unable to capture my public ip address for my remote desktop connection via my dynamic dns instead of ipBelow are some attempt I did,1) setting shorter internal time2) use afraid.org and noip.com3) reload/restart router4) debug ip ddns upda...
Hi Georg! Thank you for your reply! I followed your command, however i got some question. R1(config)#interface loopback1R1(config-if)#descR1(config-if)#description VPN L2TPR1(config-if)#ip address 192.168.2.15 255.255.255.0% 192.168.2.0 overlaps with...
Hi Balaji, Yes the "hash sha" did appear in show run all The only different now from the guide you shared now is ip unnumbered GigabitEthernet5can I set in this way? or I have to create the loopback like in the article?but i am not sure which ip rout...
Hi Balaji, In this you do not need any port forward, since the router directly connected to Internet. ( from Internet are you able to ping your Public side IP address?)yes, able to ping Any idea why "hash sha" never show up but "hash md5" do? show ...
Hi Balaji,*is the DHCP from provide is Public IP address ? which is assinged to your router*Yes, you are right R1#show ip interface briefInterface IP-Address OK? Method Status ProtocolGigabitEthernet0 unassigned YES unset up upGigabitEthernet1 unassi...
Hi Balaji, Thank you for your prompt respond, yes is a Fibre Optics ONT ISP modem, however this modem is configured only for DHCP Public IP.I do not think there is any port forward or setting be done there. I believe debug is enable, how to test clie...
