Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've got an ASA 5520 8.0(3) setup with two RA VPN groups - a "normal" user vpn group and an "Admin" user vpn group. With the Cisco VPN client, it's fairly easy to ensure only admin folks get the Admin PCF file. However, I recently setup SSL VPN as ...
My company is using the Verizon Business MPLS infrastructure to connect our sites together. Currently, each site has it's own Firewall and internet connection and things are working fine. However, at a couple of sites, we want to remove the FW and ...
I think I may need to clarify a bit...and include configs from the data center side, and a remote site...Our data center is hosted at a large facility in Atlanta. Our connection is dropped of as ethernet which goes into our ASA firewall. The firewal...
If you have nat-control enabled, you will need to NAT between the interfaces. If not, and ACL allowing the outside device to the internal router should suffice. You will need the ACL either way. Make sure you use the correct IPs in the ACL.
If you know the RW community string, you can get/put the config...see the following link. It's a bit tricky, but works great if you are familiar with SNMP.http://www.cisco.com/warp/public/477/SNMP/copy_configs_snmp.shtml
Depending on the number of hosts you have, you can subnet however you need to...Since 172.20.4.0/22 already exists, it will include 172.20.4.1 - 172.20.7.254.So, yes, the 172.20.8.0/22 is valid, but would give you 1022 hosts. Do you need that many?Y...
