Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everybody! I recently bought the device in object and I can't configure it as I wish. I followed the procedure to successfully convert the device to Mobility Express. What I cannot do is configure it as a standalone Access Point. That is, I need t...
Thank you for your answer.Please note that our network switches are not Cisco. In any case, I have no idea how to do what you suggested.Also note that we only use the AP of the device and it has a static IP address. It is the clients that connect to ...
Thank you very much!In fact, it wasn't clear that I had to assign two different IPs to the controller and the AP. Assigning the same address did not display the AP.But now I have another problem. I have configured the AP and the WLAN I want to use. M...
I'm using the PoE Injector of which I'm sending the attached images. From specification, it transforms the signal into PoE+ (802.3at). For connections we use category 6 cables. Shouldn't it be enough? Before proceeding with the purchase of an expensi...
