Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Our network is getting hit on a specific port. Is there any way (a debug?) I can get an output of addresses hitting that port, and also can I write the output to a file or TFTP server?Thanks
Hello to all. I have an 827H running 12.2(8)YJ1 trying to establish a tunnel to a 3015 concentrator. I'm having trouble getting the tunnel up and am a little confused as to the encryption settings. I am told I have to use the following:Hash Algo ESP/...
I've had a couple of goes at getting this config correct and am running out of chances. Before I test this in the real world, I'd appreciate it if someone could tell me whether this looks as though it will work. It is an ISDN hub router simply recei...
Have a 3640 that works fine for the most part, but has recently crashed with what I found was an illegal memory location and also crashed again recently with low memory. It is running IOS 12.0(7)T and I'd like to upgrade to 12.2(2)T that we have runn...
Sorry I posted the incorrect config previously. Here is the proper post.I have a 2611 in a hub site, and another at a spoke site. The hub site router is acting as a simple access router with an E1 card transferring requests to a Radius server. This p...
Hi Matt, not sure how relevant this is but I had a similar problem a little while ago in a switched NetWare environment where the users had to wait a few seconds after the splash screen came up before it would accept their login credentials as it wou...
Peter, thanks very much for that, what a trap for young players! I'm not sure if this is the existing config as I have posted an old capture but I'll certainly be checking that.Dean
