Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello all!is the transparent mode (no ip address configured on interfaces ) supported on the cisco pix firewall.Thank you very much in advance for your help. scorpions
i want to know whether cat 6000 switchs support vmps server. following is from cisco document :Catalyst 6000 family switches support VMPS client only. You must have a Catalyst 5000 family switch as the VMPS server to configure dynamic port VLAN mem...
if you want access the hosts on the high security from the low security ,you must use the "conduit " command ,"conduit" is used to establish a channel bypass the pix asa .scorpions
