Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Any idea on how to fix this problem ?Oct 10 09:46:23.493 MDT: %ALIGN-3-SPURIOUS: Spurious memory access made at 0x60D7CBF0 reading 0x36Oct 10 09:46:23.493 MDT: %ALIGN-3-TRACE: -Traceback= 60D7CBF0 60D8046C 60D61424 60D62108 605E0D74 605E1094 605E1150...
When we configure the 2600 router with "router bgp", we noticed an error message "Protocol not in this image" ? Is this related to the current IOS version which does not support BGP ? Any idea ?Cisco Internetwork Operating System SoftwareIOS (tm) C26...
One of our cisco 7206VXR (NPE-G1) processor with ATM interface for DSL clients as route-bridged type is currently experiencing a High CPU utilization with 99%. From the cpu processes, we noticed a high utilization of ARP Input. Do you have any recomm...
Jun 22 05:14:05.548: %SYS-2-MALLOCFAIL: any idea about the cause of the problem ?Memory allocation of 276 bytes failed from 0x6074728C, alignment 32Pool: I/O Free: 7040 Cause: Memory fragmentationAlternate Pool: None Free: 0 Cause: No Alternate p...
Since you are using private ip addresses for your local network, I suggest you implement cisco NAT. Implementation would be like this:interface FastEthernet0 ip address 10.2.0.101 255.255.0.0 ip nat inside speed auto!interface Serial0 ip address 203....
You can create an additional single virtual ip in your hsrp where R2 is the active and R1 is standy router. Any network using that gateway virtual IP will prefer the path via R2.
GP,From our standby router, we received the following log messages, does it causes failure to detect the hello message from the router1 (active) and resulted to change the states of our standby router to active?Standby Router logs:Apr 4 15:12:11.716...
