Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We just recently experienced an error message on one of the firewall contexts that it has reached the maximum access-list entry. Does anyone know what is the limit of ACL entry per context or where can I find the documentaton for it. Any workaround...
Hi,I'd appreciate it if someone can give me a description on how to setup two AS5350s for load distribution of analog modem inbound calls and automatic failover in case one of them fails. Thanks in advance.
Hi,Running on bridge mode, our CSM is seeing the gateway I created for the client as being down when I do the "show mod csm # arp". Below is the config:CSM:vlan 100 client ip address 10.1.1.8 255.255.255.0 gateway 10.1.1.1 vlan 200 server ip a...
This seems unusual but is it possible to turn off load balancing among real IPs and just enable failover (active-passive) among them? If this is possible, can you configure more than two passive/backup reals and just assign priorities or anything ...
Can someone please verify the maximum VLANs for the PIX 525 and what is the OS version that it should have to have the most that it can handle. Thanks.
Rick,Thanks a lot for this info. One last question related to this, with the setup that you described, did you have to run an SS7 link from the gateway to the CO? Thanks again.
