Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Remote pix need to access my local server 192.168.0.9 I am not quite sure how to configure. Below is the e-mail received from the remote tech. Also my pix config is attached. I'm attempting to ping your NAT'd IP address and this is unreachable on our...
Remote pix need to access my local network I am not quite sure on ACL needed. Below is the e-mail received from the remote tech. Also my pix config is attachedI'm attempting to ping your NAT'd IP address and this is unreachable on our end. Please be ...
VPN Parameters site to site vpnpix remote end point is XXX.XXX.80.108pix remote network is 192.168.50.0/24 pix will need to make ACL from 172.24.176.9 to host 192.168.50.83 and 192.168.50.86 pix will need to NAT intresting traffic to 172.24.176.0 /24...
I was wondering if any one kowns the command to turn off the web configuration interface on Cisco Catalyst switches. I have several 2924 XL's, and there's a security issue with the web interface.
I would like to know if anybody have a sample or a cisco page that teachs to how to configure a PIX Firewall with version 6.3 to make a user that want to access internal resource on inside, first need to authenticate in local data base (PIX) for pre ...
I am not quite sure is this what I need for the remote access my local server 192.168.0.9access-list inbound permit ip xxx.xxx.229.147 192.168.0.9 eq 80static (inside,outside) XXX.XXX.229.147 192.168.0.9 netmask 255.255.255.255 0 0access-group inboun...
Note the first show cry isa sa is before accessing a web server on the remote side. The seconf show cry isa sa is after accessing the web server on the remote site.meyerpix# show cry isa saTotal : 0Embryonic : 0 dst src ...
The vpn tunnel works fine from 192.168.0.0 to the remote site and able to access the two servers. The problem is the remote can not ping my server 192.168.0.9 What would I neet to do for the remote site able to ping.
The tunnel work no problems accept the tech folks left me this email.I'm attempting to ping your NAT'd IP address and this is unreachable on our end. Please be sure that your security device allows traffic initiated from us as well.
