Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have the below access-list that when working I have Internet connectivity on 10.252.92.1 host, but when I move 21 below the deny commands I cannot, it is like it is rejecting the permit. Could anyone help me why? To me it seems like a bug bu...
Hello,I am using cisco IR9300 L3 switch and I use the same VRF, VLAN, Routing Config that I had on a router IR1800.The issue is although I have the "Network Advantage" license I fail to have routing between 2 VRFs whereas in Router it works with the ...
Hello, I have an ASAv30 with version 9.12(3)12 and ASDM version 7.14(1), but I do not have the option to configure TLS1.3 on SSL settings. Does anybody face the same issue or knows from which version and above it is supported? Thank you
Hello, I have a pair of 2 cisco ASAv in Active/Standby mode which both are accessible via SSH but via ASDM only the Standby is and when I try to connect to Active one I take the message: Unable to launch device manager from XXXX Any idea why this i...
Hello, I am experiencing issue with HA configuration between 2 ASAv. Please find below the failover configuration for the primary and the secondary: act# show failoverFailover OnFailover unit PrimaryFailover LAN Interface: FAILOVER GigabitEthernet0/...
yes but that does not explain why on the extended access list when I deny a specific route, I lose the remaining routes on the permit that follows. Without the deny on the ACL it works properly
The DHCP on vlan103 is used cause the Ethernet connected to G1/0/2 belongs to a private IP range of 192.168.100.0/24. The NAT and routing of that IP range is done behind the switch that I am working on. This IP range is just a guest net, whatever you...
These are my interfacesinterface GigabitEthernet1/0/1!interface GigabitEthernet1/0/2switchport access vlan 103!interface GigabitEthernet1/0/3!interface GigabitEthernet1/0/4!interface GigabitEthernet1/0/5!interface GigabitEthernet1/0/6switchport acces...
Nothing a random ip to check that extended access list does not work properly.. Whatever host i try to deny on this line.. The permit to any is not working..to me looks like a bug
