Hello,I am trying configure tunnel 6to4 between CRS and 7200 but i can not find the appropiate command on IOS XR. Configuration 7200 side (IOS):interface Tunnel15 description Tunel con CRS no ip address tunnel source Loopback2 tunnel destination 172....

Hello,In show cable modem a lot of CM marked with "!". This sign "indicates that the CM has reached its maximum power transmit level and cannot increase its power level further.", but can i do something for try solve it in uBR?ThanksJavier.

Could you indicate me more information about performance of Cisco 1721 with two BRI´s interfaces with command 'dialer load-threshold 153 either', for example:-Which parameters are used by the router for calculate the threshold???-In moment of raise a...