Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Dirk,I can see that the route-map definition is not correct . The route-map must have 'match ip multicast group <>' for multicast control-plane filtering. Since the route-maps didn't have this match command and since route-maps are permit by de...
Hello Dirk , Is this a partial config that you are showing ? I dont see the default MDT defind?I am guessing that you have all these features enabled toofeature bgpfeature pimfeature mvpnfeature mpls l3vpnfeature tunnelfeature mpls ldpInculde these o...
You will have to go under the controller t1 x and assign time-slot and framing. Once this step is done you see as serial interace assigned by IOS ,See this link - http://www.cisco.kg/en/US/docs/ios/12_4/12_4x/12_4_11xw/grwics.pdf
oops ! I pasted same link for both.Here is the link to PPoE - http://www.cisco.com/en/US/docs/ios/ios_xe/bbdsl/configuration/guide/bba_pppoe_baa_xe_ps9587_TSD_Products_Configuration_Guide_Chapter.html
You cant use mgt port for data . IPv4, IPv6, and ARP are the only routed protocols supported for the interface.1. Detailed information on mgt port - http://www.cisco.com/en/US/docs/routers/asr1000/configuration/guide/chassis/Management_Ethernet.html2...
