Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a CSA Test server that we make lots of changes to on an ongoing basis. We'd like to know the recommended way to wipe out all of our changes and restore an original policy configuration. We'd also like to be able to import the policies fr...
Has anyone else had this problem? I upgraded 2 WiSM's from 3.2 to 4.0 code. Now only about half of the AP's will associate to either controller. I rebooted most of the AP's, and a few then did associate. But most do not. Should I reset the AP's ...
I created an agent kit that does a quiet install, so it doesn't prompt the user, but it does display a couple of status boxes. It is possible to do a completely silent install? The config guide indicates that it can be done but doesn't give an exam...
Believe it or not, the problem disappeared as soon as I set one of the WiSMs as the master controller. Within a matter of minutes all of the AP's that were in limbo had associated to the master. Does that sound like proper behavior or something kin...
Can you tell me specifically what Cisco considers to be the "default policies" for CSA? Does this refer to the "Operating Systems - Base Permissions - Windows" policy (containing the Required System Module and the System Bootstrap Permissions Module...
There are only about 100 agents polling this server. The poll interval is 1 hour. I'm wondering if there might be some database fragmentation or something going on. I see that for about 40 of the agents, there are two host entries. One is listed ...
I'm also getting this registration error periodically, and it has nothing to do with a valid license. The log file snippet below shows that after the agent failed to register, it was able to poll successfully and register an hour later at the subseq...
