I am a newbie to Cisco router configs. I have just purchased a CISCO 851-K9. I have a ISP which gives me a static IP and used PPPOE. I can connect to my ISP and they can see me successful connection. From the CISCO SDM software I can ping outsid...
Yes I used SDM to enable basic NAT and that did the trick. This router is blazing compared to my old SOHO one. Thanks much for all the suggestions!Mark
I can ping hosts outside my network while using the command line interface of the router, but I can not ping any host outside from any PC that's connected to one of the LAN ports on the router. What do I need to do to enable the routing from my 10.1...
I'm connecting my pc to lone of the LAN ports marked as FE0, FE1, FE2 and FE3. The WAN cable is hooked to my static IP which comes off of my ISP into my house. The connection is PPPOE but it's fixed wireless on the roof not DSL or Cable.ip route 20...
I used the SDM express to configure so these are the options it configured for me. I told the WAN that I had a static IP address and it set it up as dialer0.Thanks much for the help,MarkHere is the command output:markp#sh ip interface briefInterface...
