Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a MPLS network which is having some issues for customers using PAT. The case is if I have a CE configured with public IP address or static NAT they have no problems to navigate or do anything on Internet. But if I configure PAT they simply ca...
Actually I have implemented MPLS in my Ethernet network using Cisco 75XX as part of my core (P) and Huawei equipments for access (PE). We realized that customers can not navigate to certain pages like hotmail, msn, hi5, etc. Reviewing possible soluti...
Hi Swaroop, thanks for your helpfull answer. The NAT/PAT is being applied on customer CE WAN interface that means:CE<-->PAT/NAT<-->PE<-->MPLS<-->GW<-->INTER.Unfortunately, some of my PE?s dont support adjust MSS or MTU change (HUAWEI), thats the reas...
I was looking for Jumbo support for PA-FE-TX installed in Cisco 7507 and 7513 with IOS Version 12.2(15)T17 but i cannot find anything about that, somebody know something about this.?Thanks
OK I have an observation about this. I reduced the MTU value to 1488 in one PE as a test directly conected to Cisco 75XX. After a while a I had the same error (No navigation to certain pages hotmail, hi5, etc). On my MPLS Huawei PEs I have no option ...
Very clear Swaroop. But when I try change physicak MTU value on Cisco 75XX I received the following:===========================================interface FastEthernet0/0/0 description CONEXION XXXXX ip address XX.XX.XXX.XX XXX.255.255.XXX full-duplex ...
