Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Friends,I am trying to configure MTR for multicast with ISIS in the lab. The topology is couple of CRS1's in the core and on the edge 7600(running 12.2 SRB1) and 12K (running IOS-XR).Somehow I am not able to get the loopbacks of the 7600 advert...
Typically Dot1Q tunnelling is used in Metro-E Core based setups where the chances of vlan overlaps between customers and SP's is high.In a MPLS based Core, this might be done when the customer has a requirement to transport multiple vlans, and the SP...
Please see this document for more details.http://www.cisco.com/web/Cisco_IOS_XR_Software/pdf/XR12000_Upgrade_Procedure_3_4_x_3_5_x__3_6_x_to_3_6_1.pdfEven though everything is documented in here, please perform the procedure on your LAB routers which...
The problem seems to lie with your 7204 which has ethernet and FE interfaces for label switching. If I can recollect right you may not be able to configure physical mtu of more than 1500 on these interfaces.So the way out would be to set layer 2 mtu ...
Gaurav,Here are the links which i missed to post."Here is a link for different diffserv models configuration in Cisco with illustration if you see the configurations for Pipe model it will be more clear. http://www.cisco.com/en/US/tech/tk436/tk428/te...
Hi,Can you pls also try doing an extended ping from the hosts where you are trying to browse as below, and post the results for all.ping yahoo.com -f -l 1470 (.+2..till..1500)HTH-Cheers,Swaroop
