Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All, I have a customer who needs three wireless phones for use in a building that has wireless access points. Due to the small number of phones, I was thinking of suggesting the call manager express running on a 3660 router. The 3660 router wou...
Hello, we're trying to set up over 30 site to site vpns in a hub-and-spoke and model where both the hub and spoke boxes are pix. I know usually spoke to spoke communication is not allowed throught the hub pix. Is there any workaround or do we have to...
I have a predecessor of mine who has installed for all our customers who have Internet access, ACL for inbound and outboud internet access preventing certain bad foreign ips and dns etc etc . A Firewall is already in place so I am not sure why he ha...
I have never gone through such a upgrade. I have over 20 remote sites and we would like to upgrade all the sites to t1/ frac t1. We're also upgrading the routers at the remote sites from 2500 to 2600s. We need to do these with minimum downtime. I was...
Thanks for the respone. Today there are 56k DDS circuits, so obviously there will be a new T1 CIRCUIT. We're also putting a new router, I am how the SPs actually manage the transition. Do they provide new DLCI/PVC and delete the old one once the cuto...
You're right about the Bc and Be being used in the rate-increase. But still the example above in the URL provided is not a real-life example as it only is a point-2-point pvc. In a typical environment, you have a single T1 /T3 (frac t3)in the Hub and...
Thanks for your reply. However, it did not really answer the behavior that I have seen in testing with Be. I think the BT recommendation is right. In ur example. I dont fully agree with your example. If your circuit is clocked at 256 kbps. Then CIR ...
