Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I added a vlan to a port-channel on port the DR and the Switch uplinks.I updated the DR first C9600 vlan 1010name RONT08_PCCSinterface Po25switchport trunk allowed vlan add 1010 Then I did the access switch side C9300configure terminalvlan 1010name R...
I have a tunnel where I have access to both sides.at 12:32AM May 3rd 2024 the tunnel went down and now will not negotiate. No changes were made THIS IS THE FAR side. This is peer 63.45.114.46May 6 08:48:43.038 CDT: IKEv2-ERROR:(SESSION ID = 1,SA ...
My root bridges are the VLANS on the Distribution Layer. The DR is MEC meaning two DR's but logically are one. Portchannels going back to the access layer switches. I needed to add a vlan to the port channel for a switch. Added to the DR first al...
Found this on the Distribution sideFri, 24 May 09:25RONTGRADR01192.168.250.196notice local7 1155: May 24 09:25:20.298 CDT: %SYS-5-CONFIG_I: Configured from console by xxxxxx on vty0 (10.146.193.0)Fri, 24 May 09:26RONTGRADR01192.168.250.196notice loca...
There was not an entry on May 24th when this happened in the logs reflecting any uplink, physical or port-channel, going down.I asked an operation guy to look further but I have not heard back.
On the DRVLAN0108Spanning tree enabled protocol rstpRoot ID Priority 4204Address 88fc.5d2f.c880This bridge is the rootHello Time 2 sec Max Age 20 sec Forward Delay 15 secBridge ID Priority 4204 (priority 4096 sys-id-ext 108)Address 88fc.5d2f.c880Hell...
