Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I was previously running a Cisco 5508 WLC running 8.5.182.0 and had mDNS working with no issues. I recently removed the 5508 from my network and installed a HA pair of 3504's running 8.10.196.0 in its place. I have one SSID that all my wireless dev...
I have a 5508 controller running 8.3.150 that I have four AIR-CAP3702I-A-K9 running on currently. I purchased four AIR-AP3802I-B-K9 to replace the four 3702's that I'm currently running. My SHA1 cert is expired.Certificate Name: Cisco SHA1 device ce...
So I took the time to hook up my 5508 again and went setting by setting against the 3504 controller. On the 3504 controller - As soon as I turned on "Enable IGMP Snooping" and "Enable MLD Snooping" with the default values - under Controller>Multicast...
Unfortunately, the printer is connected via WiFi only on the same WLAN as the iPhone/iPads. The printer is advertising because Airprint worked on my previous controller. Going from the 5508 to the HA pair of 3504's is all that's changed on my netwo...
When I look at wlan>PMO>advanced P2P Blocking is set to disabled. As for if I'm using flex connect, I don't believe I am. When I check wlans>PMO>advanced Flexconnect has no checkbox next to enabled.
I have run "debug mdns all enable" but i am not getting much output on the console. Where are the logs stored or are they being sent to the console only?
