Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My question belongs to a Cisco 1712 (128 MB, IOS 12.3T, SDM 2.5 installed):I'm trying to change the default action "alarm" to "alarm,reset,drop" for all signatures of my custom set.However doing so via SDM fails. First, it appears as being done corre...
Hello,after installing SDM 2.4.1 to our Cisco 1712 (IOS 12.3(11)T8, 96 MB RAM, 32 MB Flash), I get a message that "IPS is not supported, because the router has less than 128 MB RAM".However IPS is working fine (attack-drop.sdf) and also has been acce...
We currently try to strengthen our router configuration and I hoped that some experts can take a look to our current configuration I did as recommended by some literature I found.Perhaps you can tell me what can be improved, needs to be added or even...
I have set up some ACLs already; can I use the extended firewall wizard in SDM 2.2 to set up the firewall without losing the set up ACLs ?How can I safely identify the inside from the outside interface ? I have two interfaces named "Vlan1" and "Diale...
We currently use two IPs for general purposes (website, e-mail, ftp, etc.). One IP should get priority against the other for incoming traffic.Is there a way to use the QoS feature of the Cisco 1712 for this task (or an other solution ?) ? How can thi...
Hi vmoopeung, I really appreciate your help.But what you describe is exactly the problem I'm facing with. The procedure doesn't work on IOS 12.3T, it requires (if I correctly remember) 12.4. at least.
But at least SDM should allow to manage an existing installation of the "old" signatures, shouldn't ?Anyway, I more think that this is a software bug, since at the "Configure" section, the buttons "Firewall and ACLs" as well as "QoS" are out of order...
