Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
dear gentlemen,i have one wlc-4402 controller and some clients. how to configure the netbios over tcp/ip in the controller, so that the clients can assiciate the network.thank?s in advance michael
I have one wlc 4402 and in one distribution is a 1000Base T modul from 3Com (3CS93FP).I have a fast ethernet switch, but i couldn?t configure the port. i see only link status down. What could happened.Thank?s in advancetempomat
i have one wlc 4402 controller and ap 1020 accesspoint after configuration the switch cann?t associate the ap?s. so what can i do. i have configured layer 2 with an internal dhcp server and so on.Thank?s in advance.Kind regards Michael
Dear Frank,the management port and the ap?s are in the same subnet, no firewall, now access controll list, no proxy.Must i have a distribution port?Does the controller only communicate with the ap over the distribution port?Becaus i cann?t ping the m...
thank you chris for your answeryes i set the time.must i have an ntp server?i could?nt ping the management port.so what could happened.thanks in advance michael
Hi Frank,thank you for your responce.I have AIR-AP1020-E-K9 Accesspoint.The ap?s and the switch are on the same switch.no domain.country code: deBest Regards Michael
