Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Greetings,I'm trying to connect my fabric switch to an upstream switch just for internet (layer 3). Config Interface Gig1/0/24No switchportIp address dhcp When I use a known good ethernet SFP on the C3172PQ and connect port 24 to an upstream juniper ...
Greetings,I recently acquired a 5520 ASA. I'm trying to integrate it into my environment but I am having a few issues.When I connect with my Anyconnect Client, I can ping my inside LAN GW (even pull up the web interface), but nothing else. I have a p...
If I plug that "wan" cable into a normal cisco catalyst layer 3 switch,with the same settings, the link lights up and works without issue. Seemslike nexus doesn't like dhcp clients on an base-T sfp.I'll see about setting up the SVI. Thanks for the ti...
That did it. I added a route policy for source any, dest ASAVPNPOOL (range), service any, gateway ASAInsideIntIP, interface x0(lan), Metric 1 Per here https://www.sonicwall.com/support/knowledge-base/how-can-i-configure-static-routes-in-sonicos/17050...
Do you mean, a static route on the Sonicwall FW router? Or the ASA FW? pointing from what to what? the vpn 7.x to 20.251 (the asa inside ip)? or inside 20.x to 20.251 (the asa) Do I need to deal with the Verizon router as well, telling it where the 7...
Maybe I need to set a route on the Sonicwall? The default gateway to the 20.20 (pi/server) is the 20.1 Sonicwall gateway. Do I need to tell the Sonicwall where to reach 7.x (anyconnect client pool) which is through 20.251 (inside int on ASA)? Or does...
