Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
dear networkers I have tried to configure the Cisco router as a DNS server, Unfortunately, I did not make it, I don't know the reason. would you please figure out why the latest version of the packet tracer rejected the DNS command?
how does a client(PC) get a DNS address while it uses auto-configuration based on using the EUI-64? i have tried to configure as follows, it works good getting the ipv6 address (prefix and prefix length), default router but it is missed the very impo...
Peace upon you brigadiers !Does it make sense my question?A host uses the address/mask combination of 192.168.32.99 255.255.128.0. If all subnets of the same class A, B, or C network use that same mask, how many bits are used for the subnet part of t...
The role of all data-link protocols is to control the correct delivery of data over a physical link of a particular type. For example, the Ethernet data-link protocol uses a destination address, which is the MAC address, field to identify the c...
thanks for your solution and here the correct configuration
Router>EnableRouter#Config tRouter(config)#Router(config-if)#int g0/1Router(config-if)#ipv6 address 2001:abc0:10:20::1/64 eui-64Router(config-if)#no shRouter(config-if)#ipv6 enableRouter(con...
