Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am using Comcast's residential service with an RV340 and a NETGEAR Nighthawk Cable Modem with Voice CM1150V. I have configured IPv6 to be enabled. I seem to be able to get a DHCP IPv6 address at the router (WAN port 1 reports an IPv6 address up i...
I have 2 kindle fires I'm trying to set up. When I enter the 10 digit meraki code in the Meraki SM app I am immediately prompted with a login. The app does not say which account it's asking for but I assume it's my gsuite account that's tied with m...
This fixed my issue too. The description exactly matches my experience. I went months with xfinity's gateway because I thought my old modem was the fault. Saw the new modem with this issue and googled "rv340 xfinity no internet" and found this. T...
I have no idea why this fixed it and I'm not even 100% sure it did, but I searched some other forums and thought it had something to do with route advertisements. I couldn't modify the routing table in the GUI and I was about to see what CLI stuff m...
I'm editing this post. I rebooted my router and cable modem and was able to get my IPv6 back up on the WAN1 port. I have added screenshots of my vlan and wan1 configs. If I manually enter IPv6 information in windows 10 I am able to get what I belie...
