Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have VPN setup between a 1710(branch) and 1841(core), and wanted to test it without using split tunnelling. I was told that to enable this, I just need to specify all of the VPN traffic in my VPN ACL. I did this(Permit ip any any), and the...
Hello,I'm trying to create a VPN tunnel between a 1710 at a branch and an 1841 at the core site. I've successfully done PIX to PIX VPN's(at a different company) but not yet with these 2 routers. The branch site is using DSL, and the DSL router is s...
Hello,I have a PIX 501 that is connecting to our main ASA 5510. The 5510 is the hub and the 501 is the spoke in our VPN setup. All other spokes in our network are working fine. One of our sites is having a problem. The PIX will load up, and work ...
I have a P2P link between a 2610 and a 2621 router that is experiencing heavy CRC and Frame errors. We replaced the 2621 router outright with an 1841 thinking the issue was on that end. When we did this, the site went down completely until we swapp...
Hello,I'm looking into disabling streaming audio/video on our PIX firewalls. Does anyone have any information on this? I found a cisco white paper on the internet for disabling P2P software which was very helpful, but would like to disable the stre...
Yes that is what I'm trying to do, and I think its working partially since the web traffic not working tells me something has changed. Here are what my 2 VPN acl's look likeaccess-list 100 permit ip any anyI also added this line to my NAT acl at the...
After my initial setup, web and vpn traffic were both working. I started toying around with disabling split tunnelling, and that is when the web traffic stopped working. I need the web traffic to work though, but I want the traffic to go out the in...
ASA(Config is too long to fit here, I'll post the parts necessary. All other sites are not having this same problem):access-list NONAT extended permit ip 192.168.100.0 255.255.255.0 192.168.51.0 255.255.255.0 access-list NONAT extended permit ip 192...
I have read up on a product by Cisco(the name escapes me at the moment) that would act as sort of a VPN server. Your remote sites would all connect to a central server which contains information about all of your sites. Lets say remote site 10.4.x....
