Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI am getting this error massage on my Meraki I don't know why Meraki blocked the Umbrellas Any idea ?Content filtering blocked URLurl https://doh.opendns.com/..., server 146.112.41.2:443, category Proxy Avoidance and Anonymizers
HI,I have Cisco Firepower FTD 1010, and due to the fact that we need high available network, i have question if i can order another FTD 1010, and configure both devises with High Availability Active and Standby.Now i have one FTD1010 connected to 3 C...
I have Z3 and i found this in the logsource_client_ip: 192.168.1.113, source_client_mac: 20:4E:F6:CB:15:3D, source_client_assigned_vlan: 0 « hidelast_illegal_ip100.115.92.14client_total_illegal_packets558all_total_illegal_packets2973last_reported_to...
I have local website behind FP1010 FTD and its not workingwhen i started the RAVPN was using the legal IP with port 443, and this server is pointed to the same legal IP and for sure use the same port 443so when you open the website the vpn page to do...
@Karsten Iwen Thank you very much again Yes after upgrading my FP1010 i can see the switch port now so i have 2 smart switches connected to port 2 on the FP1010 and each one will be configured with switch port, with the native VLAN, and allowed VLAN ...
I am not sure if i get you correctly above is my interfaces I am using Ethernet 1/1, and Ethernet 1/2 as WAN interface And rest of the ports i need to use them to connect my 3 switches as a stunk on VLAN 1 and create DHCP for all the uses, and allow...
