HI all, I am new to VPN.I am having a PIX-515 firewall.I want to configure VPN in PIX so that remote clients will access the server inside my firewall.The clients will be dialing to the server thru ISP.Can anyone help me with the very baci...
HI ALLI configured 2511 for accepting dialin users.I am unable to communicate with the modem using reverse telnet.The modem is Zyxel .I have tried all options given in cisco documentation.I also need a sample configuration for the following scenario....
hi all I am having problem in rate-limiting in my 2948g l3 switch.can any one help me.I want to rate-limit on one of the fast ethernet port for both input and output traffic.Let me know the command for it.
I have set the speed to 9600 and tried still i am unable to connect.The line speed is not getting locked.If i type "sh run" the line speed varies form time to time.What may be the problem?
I am using a RJ-45 to DB9 connecter to connect the asnyc line to the modem.The modem supports only DB9 connector.The line speed is not getting locked.When ever i give sh run command the line speed differs from time to time.When i reverse telnet into ...
I am in progress of configuring the 2511 router for dial in.Now i am unable to reverse telnet into the modem to configure it.I have selected modem autoconfigure discovery,but the router is not communicationg with the modem.And also i am unable to rev...
I have already done what u have said.My problem is as follows:Router(config-if)# rate-limit input {32000-100000000} {0-64000} if i enter this command its saying incomplete command. I have entered the following command: Router(config-if)#rate-limit in...
Router(config-if)# rate-limit input {32000-100000000} {0-64000} if i enter this command its saying incomplete command.I have entered the following command:Router(config-if)#rate-limit input 100000 8000 8000 conform-action transmit exceed-action dropw...