Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a standalone NGFW 2110 with AnyConnect configured with there are several issues going on, and not sure if one is impacting the other. 1) Can't ping e1.7subif or e1/8 subif from the fw. However, e1/3 subif ping just fine. 2) When clients conne...
Looking for a solution to my issue: I have a Cisco NGFW 2110 running v6.6.1 and the VPN client had been working. Short story is I blew away the VPN config because users complained they had no access to the back-end resources after connecting. Now it'...
Looking for some guidance around the following setup: We have two Cisco NGFW 2210 (running 6.6), and also have two ISPs (Comcast and AT&T). The HA pair are being managed by FDM (with no intentions of using FMC). I have not seen any documentation t...
Here's the latest packet tracer from a VPN to an inside host packet-tracer input vlan30 icmp 172.16.100.1 8 0 10.11.30.2 detailedPhase: 1Type: ACCESS-LISTSubtype:Result: ALLOWConfig:Implicit RuleAdditional Information:Forward Flow based lookup yields...
Question 1, yes I do have a explcit rule to allow vpn clients to internal vlans. Question 2 regarding NATs is my skill set weakness.. here is what I have today: > show natManual NAT Policies (Section 1)1 (vlan48) to (outside) source static NGFW-Rem...
