cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1249
Views
0
Helpful
4
Replies

Cisco 2110 - HA with Dual ISPs

Looking for some guidance around the following setup:

 

We have two Cisco NGFW 2210 (running 6.6), and also have two ISPs (Comcast and AT&T).  The HA pair are being managed by FDM (with no intentions of using FMC).  

 

I have not seen any documentation that supports an active-active configuration based on current version (v6.6).  

 

Has anyone setup these appliances with active-standby with FW1 (ISP1 + FW2 (ISP2).

 

 

4 Replies 4

balaji.bandi
VIP Community Legend VIP Community Legend
VIP Community Legend

FW1 (ISP1 + FW2 (ISP2).  - no this is not possible high level - until you make them standalone mode

 

but you can do PBR to route the traffic to ISP1 and ISP2 to split the load between 2 ISP - is this works for you below guide help you :

 

https://www.youtube.com/watch?v=MKcSBTJ55e8&t=18s

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

I don't think this is possible as i have the same issue with my FP1010 (running 6.6), and also have two ISPs. if you have FTD managed by FDM (with no intentions of using FMC).  

This is Cisco Bug note 

https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvb19682/?rfs=iqvred

 

https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvo39894

 

This doesn't make sense at all to have a limitation for Dual ISP Load balance and failover, 

Using Cisco its really strange 

if you have any other suggestion please advise 

I know FDM has limited features, only to manage certain features, For full working featured cisco suggesting FMC requirement.

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers