Hello. If you can, please take a look at my last reply to Georg. I included my commands for the T1 c...

Hello. If you can, please take a look at my last reply to Georg. I included my commands for the T1 c...

Hello Georg; Here are the configurations for both Router1 and Router2. These are the commands I issu...

No, same as before...when I did a service-module ? at the prompt, this is what resulted: Embedded-Se...

Unfortunately, I receive an error msg when I try to enter the commands at either router. Error msg i...

Thanks for that suggestion.  I'll give it a try later and let you know.

Here's the thing, I have installed on the Cisco 1921 routers: VWIC3-2MFT-T1/E1 - Cisco 2-Port T1/E1 ...

This is quite frustrating, to say the least. Here is some configuration data:PC1- IP 192.168.101.2/2...

I have a simple physical network of one Windows 10 laptop, a 1921 Cisco router, a 1921 Cisco router,...