Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Trying to setup Dual VLAN (Different Subnet for Wired and Wireless) on 877w for and seem to be stuck somewhere where VLAN2 is stuck on up/downWIRED - Vlan1 - 192.168.1.1 / 24WIRELESS - Vlan2 - 10.0.0.1 /24I have disabled all the bridiging and all ...
It most likely a driver issue, I have faced this problem and reseating the USB cable sometimes fixes it. Do check the COM port because it usually changes.
Can you please explain why the following is there...? Have a packet capture and see whats going on...router bgp xxxx bgp log-neighbor-changes neighbor x.x.x.x remote-as x.x.x.x neighbor update-source GigabitEthernet0/1 maximum-paths 2
How many BGP peers do you have? 1?Weight is locally significant and also check the hold-queue, as "Cisco recommends that the queue size not exceed ten packets on asynchronous interfaces"I would do a packet capture and see whats going on...
