hello, I have made a topology by using one 3560 switch and 2 2950 switches. I have also made 2 vlans name Clients and other Servers and vlan 1 is for anagement purposes. The left 2950 switch is for clients and the right is for servers. Clients ...
Hello, i have made a topology in packet tracer related to etherchannel configuration. i am using 2 3560 switches and 1 2950 switch. Now what i want is to bundle up the redundant links between these 3 switches. The links fa0/1-3 between 2950_1 a...
Hi, I been practicing with the configuration of layer 3 etherchannel configuration and i am facing a problem here. I have two 3560 switches and i want a layr 3 ether channel configuration setup between the first 2 ports of bothe the switches. I ass...
hi, I have a made a topology in pkt tracer. i have made use of a router and switches. i placed dhcp in vlan 2 and my clients are in various vlans ranging from 3-7. Now i have made sub-interfaces on my router to implement router-on-a-stick technique...
hi, I been going through some questions to clear concepts and this question about redistribution confused me. I think the answer is A the guide says its C. so correct me if i am wrongplz look at the imgRegards,Ali
I figured out the command. i was using an older version of pkt tracer and t wasnt allowing the ip helper-address command and i got confused but its all good now. time to move onto HSRP and VVRP. But thanks for the guidance fischer and soroushm.Regard...
So what it means is that etherchannel config should only be done between layer 3 switches and these switches are normally at the core layer.Regards,Ali
hi, It might be for incase of failure such that if link on side goes down data can still be sent from alternative path and if you check the configuration of these 2 switches rstp might also be enabled on those switches and 3rd reason is the trunki...
Hello Henrikp92, Thanks for the reply back. I dont need a routing protocol in this scenario i think because my 2800 rtr will directly connect to the ISP router. right? i will try this and will get back to you asap.Regards,Ali
Hi Henrikp, ok now its working fine and now all my blocks are getting ips from the dhcp. thanks for the help. Now my second question is that once i have achieved this portion and now if i want to connect my 2811 Router to the ISP i have...
