Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Folks, I tried to boot from a USB my server B series. I insert the USB into a KVM dongle an set the policy as below Local FloppyLocal CD/DVDRemote Virtual DriveCIMC Mounted CD/DVDLocal Disk but didn't work.
hi folks, I created two vSAN one on the fabric interconnt (vSAN ID = 100) A and one vSAN on the fabric interconnect B vSAN ID (200). I created the same on MDS A (vSAN 100) and vSAN 200 on the MDS B. I changed the vHBA template vSAN from the default ...
Hi Folks, I have the following setup:- fabric interconnect connected to one upstream switch.- mac address of the OS's Blades are learned by the switch but the blades can't communicate to each others.- it s baremetal installation.
Hi folks , I had an issue when failover the ASA from the primary to secondary node. only one group fails to the secondary node.below some outputs. ASA# show failover stateState Last Failure Reason Date/TimeThis host - SecondaryGroup 1 Failed Ifc Fai...
Hi , sorry, I didn't apply the change well for the first time.when I designate native vlan on the vNIC , the node ping each other.so , this native vlan doesn't impact other vlan if i try to reach them. as each vNIC is affacted on different vlan ?vlan...
hi , Is the FI nxos level, showing the macs learned in the vlan you expect them in? no mac is of vNIC is learned by the FI. mac are learned only by the upstream switch.
Hi ,below my answers. Are these all in the same vlan and subnet?yes , they are in the same vlan and subnet. linux is installed as baremetal on blades with diffrents vNIC. I configure one interface from each blade in same VLAN/subnet and try ping.Are ...
