Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a number of FTD devices that, due to a deployment mistake, were all set to the same Unique NAT ID when registered to the FMC. It all works surprisingly well considering the issue, but only if 1 device establishes its connection at a time. How...
My company uses Firepower firewalls in a hub/spoke site-to-site vpn topology and use Meraki wireless access points. That all works as expected and the two platforms don't interact with each other than passing packets.My question is if it is possible ...
I have an odd issue that I can't understand. It isn't exactly a huge issue, but I would like like help understanding what is happening here, because I don't get it. 2 floor office with a Cat9300 stack on each floor. We don't have a huge number of dev...
Our regional offices have Firepower FTD devices (without FMC), each with two VTI interfaces to the data center, routing via BGP. We want to use DHCP Relay to point to a remote DHCP server (due to FTD's DHCP lacking needed config options). I don't wan...
I just installed a new FTD in Azure (standalone, not managed by FMC), running 6.7.0-65. I so far we have done no config, just set set a single static route to access our VNET and enabled management over the inside data interface. Getting a ERR_SSL_VE...
EDIT: I can confirm that setting the switch directly connected to the firewall as the STP root corrected the issue. You are likely correct and I will give your suggestion a try. However, I am still struggling to understand the interaction. Why would ...
Redeployed the VM and got the exact same results. I reread the description and it does look like this requires some kind of management solution. I guess it doesn't support local administration.
One more clue, I have a FTD 1010 in my lab, I watched it boot via the console, noticed the following...Starting Cisco Firepower 1010 Threat Defense, please wait...No PM running!
...started.
Cisco FTD initialization finished successfully.Every console...
Typing exit closes the session, I can reconnect and log back in, but I get the same linux prompt.This is a guess, but it is acting like the FTD software isn't starting, like I am only getting the underlying linux OS.I was wondering if there was a lin...
As I said before, I already know all of the IP addresses, but none of them have https:// open.I tried typing the command you mentioned and it does not work (again, I am at a Cisco Fire Linux OS prompt) Cisco Fire Linux OS v6.7.0 (build 62)Cisco Firep...
