Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have asked before, but still having a problem that I guess I am not getting. I have a 1262. I have two antenna. One that is omni at 5Ghz for outside and another that is a 2.4Ghz omni. I can connect to the 2.4Ghz inside the building but f...
Hi all,I am a newb at this and was hoping someone could help lift the shroud. I have a WS-C4507R-E switch. The current SW Ver. on it is 12.2(53)SG4-IP-BASE-CRYPTO. I have been tasked with making sure all of our switches and routers have the most c...
Hi all,Have a question that I was hoping someone could help me with. I have recently installed a 1262AP. It is up and working great, on the inside of the building. I had the idea that I would purchase 2 antenna, one for inside the building and one...
Hi all,Just wanted to get a little help here. I am a bit green on routing and setting up routers. I have never really had to do it in my career, but I find myself needing to re-educate myself. With that, I have a Cisco 867VAE-K9 router. I am conn...
The power was not touched. I set everything up as far as range and throughput through the web interface of the device. Both of the radios was set for "best for range", but with the problem of me standing right over the AP with my phone trying to co...
Oh...I wasn't offended at all, or thinking you were trying to be. So, I was leaning towards a "bad" device as well. I don't think the antenna is even a question right now. I was standing over the AP with my iPhone trying to connect with the 5GHz ...
Ummm...Im not sure if I should reply with a gleeful "You betcha" or be completely offended? If you really would like me to, I can, but I assure you that the antenna was plugged in to the correct spot, and on the off chance that it was a bad antenna...
Alrighty....so, I took the 5GHz antenna down and plugged it directly into the AP. Got nothing!! Disabled the 2.4GHz radio, and got nothing again. So, it would seem, that even though the 5GHz side is showing as up, it is not Tx or Rx. Soooo.........
Yes....as you and Steve have been helping me with this and giving more information, I have been researching more on that info (odd how you can't seem to find answers until someone points you in that direction). With a 200ft coax, that is up to 60% s...
