Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have 2x 2120 Cisco FTDs(managed by FMC) in the DMZ. Primary/Active FTD has a single L3 link to EDGE 1 and Secondary/Standby FTD has a single L3 to EDGE-2 switch. We are planning to deploy VPC on the EDGE switches where each FTD is going to have t...
Please check out the attached network diagram for more info.We have a Layer 3 switch and ip cef is enabled(default load-sharing-per destination) on all the interfaces in that Layer 3 switch. We have 2 equal cost paths to the default routes.(One point...
Thank you @balaji.bandi @Marvin Rhoads for taking your time to reply to my question. When I'm removing the existing L3 interface config(and associated zone and interface group) on the FTDs, will that wipe-out the config on routing and policies associ...
Thanks Martin. That makes sense. When the router performs "software processing", does that look solely at the routing table for packet forwarding? Does the router have an load sharing algorithm when performing "software processing" if there are equal...
