Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a simple network with an ASA5505 mainly used for AnyConnect so there is little traffic. There is 1 laptop connected to the E0/1 of the ASA and then E0/0 is going to the internet port. I've noticed about ever 15-20 minutes, I lose all connectio...
I am able to successfully connect to my ASA5505 via AnyConnect via a mobile device. Upon doing so, I lose internet connectivity. My access list appear to be correct to I'm sort of at a loss. Any help? ThanksASA5505# show run
: Saved
:
ASA Version 8...
I recently set up an ASA 5505 with AnyConnect. Its a very simple set up. I have the ASA 5505 (E0/0) that is plugged straight to the ISP private static IP address. I have a computer connect to the console port for configurations. I also have 1 lap...
I've found tutorials and guides on how to configure AnyConnect on an ASA5505, but I wanted to check before to make sure I was going the right direction. Setup:I have a very simple setup and basic goal. I currently just have one laptop on E0/1 of my...
I've been trying to get an ASA 5505 configured correctly to let a laptop on one of the ports successfully browse the web. Afterwards, I'll set up AnyConnect but thats another story. I previously had a thread where I had lots of help, but unfortunate...
I stlil waiting on a response from my IT department. I have noticed that on my arp tables, I do get an IP address that shows up and I'm not sure what it is. As I mentioned before, the network I'm working with isLAPTOP <-----> ASA <-------> INTERNE...
Thanks, I'll reach out to them. I do notice I occasionally get another entry on my arp table on the outside interface with an IP very similar to what I have assigned to me. I suspect that is probably what is causing my problem.
Thanks for the reply Varun.I waited until I lost connection and did what you suggested. )# show cap capin6 packets captured 1: 13:42:28.785695 802.1Q vlan#1 P0 192.168.1.4 > 4.2.2.2: icmp: echo request 2: 13:42:29.786092 802.1Q vlan#1 P0 192.168....
I hopped my working device on the 166.188.X.X network and was also blocked from the Internet. What can I add to ensure that all devices connected can still freely browse the web? Thanks in advance for all the help!
