Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All ,
I had a brain storming session with my colleague and we could not figure out the design question.
IWAN HUB DC
| |
| |
MPLS INTERNET------Remote Site 1
| ...
Hi ,How can i find the list of features supported in ASR for various license1) IP Base2) Advance IP Services3) Advanced Enterprise Services.FYI: I did check the the FN and it was not very helpful. It would be great if some one can point the document ...
Hi, I am facing the following problem.I have a switched network built over VPLS Cloud.Switch1---VPLS-CLOUD-----Switch2Switch 1 is root switch and there are multiple switches connecting to VPLS cloud including switch 2.All were working fine until one ...
Hi ,
This is IWAN . I am planning to run BGP both MPLS-DMPVN Tunnel and also Internet DMVPN Tunnel . .
In such a case, Remote site 1 will only learn the route from Hub site . But when traffic starts ...NHRP will point the route directly to Remote ...
Can we use Flex VPN as simple overlay without any IPSEC applied to the tunnels. Use case here is that , there is no IPSEC is required but simply we need overlay to hide the underlying network as it is done in Cisco IWAN?Thanks and RegardsArun
Hi Giuseppe,Thanks very much for the reply. Problem with my setup is that , my switched do not detect the topology change.For example . I have two ports connected via QinQ facility (offered by a external provider) between root and non root bridge. Wh...
