I have a router with two separate OSPF NSSA process running on it. I can see in the OSPF database that it has two default summary routes learned from the two separate ospf NSSA. However in the routing table it only keeps one default summary route. Bo...

I have two routers directly connected. Both Routers are running RIP. Router AFastEthernet0/0 10.2.1.1 / 24 FastEthernet0/1 10.1.1.1 /24 OR /30 Loopback0 10.10.10.10 /30 Loopback1 ...

I want to lod balance two servers using CSS 11503. The requirement is to send all the traffic to Server1 untill it dies. Meaning that...Server2 will be sitting idle and only become active when Server 1 is not available. I am not sure which load balan...

We recently scanned our segment and found out that router is responding to some ports which are unknown to me. One of them was port 79 , which is finger port. So I can stop the finger service to block the port. There were some other ports for which I...