About EugeneKLISTORNY96247

EugeneKLISTORNY96247 · 02-08-2021

I am trying to configure the Cisco IE-5000-12S12P-10G switch to allow two servers connected to 10G SFP+ ports to communicate up to 10Gbps rate.Both servers are connected to the switch over the CAT7/RJ45 cables via 10G RJ45 transceivers.All ports are ...

EugeneKLISTORNY96247 · 02-09-2021

I found the root cause of the issue. The mtu size in the computer's network card was set to 9K however the switch port set to the default 1500. Once I change the computer network settings the connection rate increased to 10G.

EugeneKLISTORNY96247 · 02-09-2021

Here is the command output:show int statusPort Name Status Vlan Duplex Speed Type Gi1/1 connected 1 a-full a-1000 10/100/1000BaseTXGi1/2 connected 1 a-full a-1000 10/100/1000BaseTX...Gi1/21 notconnect 1 auto auto Not PresentGi1/22 notconnect 1 auto a...

Member Since	‎02-08-2021 10:51 AM
Date Last Visited	‎02-10-2021 12:15 AM
Posts	3
Total Helpful Votes Received	5

User Statistics

User Activity

Configuring Cisco IE5000 SFP+ interfaces

Re: Configuring Cisco IE5000 SFP+ interfaces

Re: Configuring Cisco IE5000 SFP+ interfaces