Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i have set up a asa in active active config i am able to ping outside interface from the asa but if i connect a host and try to ping i am not getting any reply
Hi,i have configured multiple context on ext firewall , created subinterface and configured failover in external firewal it works fine but unable to ping the router ,there are 2 different link for the router and there is no rdundancy at router level ...
Hi,I recently bought a 2811 router ,I have just installed a 1FE HHWIC CARD,but when i power on the router ,it is not getting detected ,is there any setup for installing it or wheather the part No. is incorrect,please give me the correct part no.
i have 2821 router with 2gb int one is used for isp and other for the firewall i am planning to add one more isp from different vendor which will be used only for a set of systems only those will be using the link other will go via exsisting isp how ...
Hi, Francisco,Thanks for the reply,I would like to go in for active active config for ASA ,and i would be stacking both the 3750 also what are the other options to have this implemented .
Hi Francisco,yes you are right,but one MPLS other is Internnet link,MPLS is for internal access and Internet is for Public access ,please suggest as to how shold i configure the router and ASA .
Hi Paolo,Let me clarify the ISP are terminated to the switch ,then it gets connected to the router ,i have only 2 int one i am using it for inside interface other for uplink to the switch,in this scenario please suggest weather to go in for creating...
Hi Jon,I think you are not getting my point i have attached a network diagram as well as config of my 2nd router i have 2 different isp which is connected to 2 different routers currently i am concerned about my 2 nd router i have configured the core...
