Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am teaching a CCNA course using 2500 series routers with Version 12 IOS.I am getting this peculiar problem of not being able to ping Up/Up serial interfaces using their assigned IP addresses.I can ping the loopback IP address.Initially I thought it...
i am trying to network my centrino notebook thro a smc wireless router.there are 4 pcs connected by cat5 to the 4 lan ports of the smc router.initially at the notebook i added the lan,firewire and wireless interfaces to the bridge,assigned a static i...
I am using the Cisco 5 router configuration to teach 1st year classes as in Cisco Networking Academy program.I faced a strange problem whose cause I am unable to fathom.After the routers are set up I can ping from any router to any router.However fro...
Thanks for all the suggestions.My next class is on Saturday.I will post all the configs etc. if I am still not able to resolve the problem.Although I did not specifically enable IP routing the connected interfaces were showing up in show ip route.I w...
I believe the neighbouring interfaces were in the same subnet as we were doing a example scenario from the official CCNA guide.Show CDP nei showed up all the neighbouring interfaces etc.Could you elaborate further on the IP Routing track.
The configuration is:Desktop PC running Windows 98a)Desktop NIC connected by cat-5 straight through cable to switch Ab)Hyperterminal running on Desktop connected through console cable to Router A console portc)Switch A connected to Router A ethernet ...
