Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello. I am trying to get my first vlan setup to work and cannot inter vlan route. I can't see what I'm doing wrong at this point. Can you help?Edit: The switch is an SG350-28P. Latest firmeware. I'm using two SVI vlans 10 and 20. Also have the defau...
HiI am trying to get my head around layer 3 switch routing and am missing the link between vlans and ports.I'm configuring layer 3 with SVIs.My switch is an SG250-08HP. I have exec IP routing.I have added a vlan 10,20 with no shutdown and the switc...
I would be grateful if I could be pointed in the right direction. I have Vlans configured. Is it possible to route between PC(Vlan1) and pc(Vlan20) but only based on their ip address or macid?I dont want all devices in both vlans to be accessible to ...
Thank you for those points. How do the SVIs route between them, and what interface to go to for dns or the internet? Vlan1 is connected to the router ( 10.10.1.2 to router 10.10.1.1). But how do frames on vlan 20 (10.10.20.1) know how to get to vlan...
Oops sorry. Missed that. The switch is an SG350-28P. Latest firmeware. I'm using a Draytek router but only offering one interface of vlan 1 to the switch.
Hello again Richard. Thank you again for you detailed reply. You have given me much to think about and digest.I use a Draytek 2927 router that provides inter vlan routing but no way to control access between a two connected vlans.I need to place a PC...
Thank you Robert, that was explained well and took some of your time. So the layer 3 SVIs are normally on a trunk port to the router, if it is router on a stick setup. That is where the routing between VLans can take place because the svi is associat...
But use of switchport is layer 2. "Enabling a switch interface to be a routed interface instead of a switched interface is simple: just use the no switchport subcommand on the physical interface. Cisco switches capable of being a Layer 3 switch use a...
