Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,
Thanks to a very useful community answer (Can BGP be Routed Between 2 SVI's), I now know that I can use SVI's as BGP neighbours. However, I am very new to being hands-on with BGP! Is anyone able to help out a little with some of the...
Hello, Normally, BGP s routed between layer 3 interfaces with networks advertised and such. However, I was wondering if it is possible to use BGP between 2 Vlan addresses. For example: In the attached diagram, I am hoping to use it between each site'...
VLAN Name Status Ports
----- -------------------------------- --------- -------------------------------
1 default active Et1, Et25, Et26
151 VLAN0151 active ...
Et1 Site-1 connected trunk full 10G 10GBASE-SR IP RouteVRF: default
Codes: C - connected, S - static, K - kernel,
O - OSPF, IA - OSPF inter area, E1 - OSPF external type 1,
E2 - OSPF external type 2, N1 - OSPF NSSA external type 1,
...
Hello, Apologies for the delay, I went to sleep! I cannot ping from 10.101.1.2 from the core switch. I'll post the configs and bgp sumarries for you. Core SwitchRunning Config:vlan 151
!
vlan 253
name IB-MGMT
!
vrf instance OOB-MGMT
rd 100:100
...
