Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,I am setting a fabric with 3 APIC M4 having VIC 1455 cards ... Each APIC VIC port-3 and VIC port-1 goes to Leaf 1 and 2 according to the topology below. Problem : APIC 1 can't see other 2 APICs. APIC 1 registers Leaf 1 and Leaf 2 but each rem...
Hi guysI got a couple of inquiries regarding security devices : FPR1150, ASA5525, ASA 9.16 software, FTD software.- On ASA 9.2, how to remove failover information on the hostname ? Example : gain back ciscoasa# from ciscoasa/pri/actNoFailover#- FPR-1...
Thanks for the confirmation on the cabling, i was worried ...I went through the Fabric membership tab and did a couple actions even before. bottom line is I can register Leaf 1002 but the status remains inactive and never changes.Did assign ID 1002 t...
Thanks a lot @Rob Ingram , this is clear... About the FTD image, is there an alternative to go without FMC.I mean, Firepower 1000 series supports Clustering (Datasheet). Can we go with CLI ? https://www.cisco.com/c/en/us/td/docs/security/firepower/co...
Hello Aziz,There are few situations (like multicast) where you would want to configure a same IPv4/v6 address on 2 different devices. Your scenario does not seem to be one.
