Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
It confused me.. So I tried it myself in a lab. I use mode active in a cross stack environment. It works perfectly. When I take a look at your config I see a speed setting at the portchannel interface. I tried it and now I have the same issue. Remove...
You should take the settings "channel-group 6 mode active".From Cisco.com "PAgP cannot be enabled on cross-stack EtherChannels while LACP is supported on cross-stack EtherChannels from Cisco IOS Software Release 12.2(25)SEC and later. "LACP = mode ac...
