Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All, I am trying to configure a new ASA 5508-X. I am running ASA 9.8, ASDM 7.8, and the FirePOWER version is 6.2. All came pre-installed and licensed. I am trying to manage the FirePOWER via ASDM, I do not have a Management Center. When I conn...
Let me start by saying nothing has changed since my 2/24 post. I think the problem is with ASDM and/or Microsoft Networking based on what I observed this morning. Previously I was working from a Windows Server 2016 at 172.21.4.22. I am still getting ...
This morning I still have the same problem even after reloading the ASA, "ASDM did not get a response from the ASA in the last 60 seconds", I also noticed that the Configuration Tab in ASDM is disabled. The FirePOWER module is still configured as 172...
FIRST I ran a cable from Gi1/2 to a management network switch. Nothing changed. NEXT I tried reconfiguring the FirePOWER module to use the management network switch as the gateway, "configure network ipv4 manual 192.168.10.2 255.255.255.0 172.21.4.6 ...
Thanks John, that sounds promising and I will try it. I am not an savvy network engineer. The switch is 172.21.4.6, should this be the gateway address for the FirePOWER module? In all the examples I have seen, the FirePOWER address has always been 19...
