Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I need continuous output (Not Page by Page with --- More --- prompt)for "Show interface" command from Cisco 4507 switch, so that it could be passed to a script for calculating incremental CRC, Collisions etc.I use "Terminal length 0" command befor...
Hi,I am using ASA 5510 appliance in a test environment and noticed that from inside network I can ping most of the IPs on internet for example yahoo.caBut I can NOT ping Public IP of my own servers which are statically natted on my ASA and trying to ...
Hi,I have a similar question joerg.micheel already asked about Configuration Synchronization of CSS boxes.My first box CSS-1 is already setup with the config as shown at the bottom (excluding Services, Rules),and i have already reserved IPs for CSS-2...
I have following question on IPS redundancy, we have purchased two ASA 5510 units , each with built-in ASA-SSM-10 module.Our main focus is to use the Active/Standby redundancy for the firewall (which is straight forward)When the Active Firewall fails...
Hi Guys,I believe in PIX series, in a Failover Pair using (UR-FO) license combination, if PIX with UR license fails - The PIX with FO license takes over, But now if this PIX with FO license reboots (for amy reason) then it is treated as a Standalone ...
Hi David, Just saw your question in the middle of this thread which i initiated few months ago and finally the issue was resolved, so i thought if you are looking for the same solution,as per your description 172.17.150.0/24 is your inside network an...
Hi abinjola,OK It finally worked, your advice was really VERY helpful, I had to tweak it a little bit as below,same-security-traffic permit intra-interfacestatic (inside,inside) 66.48.x.y 10.10.40.254 netmask 255.255.255.255static (inside,inside) 66....
abinjola,The FTP Server (172.16.70.200) is actually sitting in the same subnet as the Web Servers.Thats where the the Problem lies .Otherwise for any client in a different subnet doing http access, targets Farm IP 10.10.40.254 ( or 66.48.x.x for Inte...
OK, here is a bit more detailed description :A very standard setup having an ASA 5510 firewall (Outside 66.48.x.x ; inside 10.10.40.5) behind that is a CSS 11503 Load Balancer (outside 10.10.40.3 ; inside 172.16.70.3), behind CSS there are bunch of W...
I've now resolved this issue after getting second CSS Unit in-hand.The Synchronization script actually copied all the configuration such as DQL, Owners, Content Rules, Services etc from Active Unit to Standby Unit. But The Interface IP addresses were...
