Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello guys, I am following an online course with FTD and FMC. when I try to add my FTD to FMC I get en errorCould not establish connection with Device
Possible reasons could be:-
- Time on FMC and Device are not in sync. Make sure NTP is configured ...
hello guys, I have installed a FTD image on the Cisco ASA 5506-X K9 and now I have forgotten the admin password, therefore I can not log into the system at all. for the reimaging, I must enter the cli too, but I can't either. when I use the confreg 0...
hello guys, I have installed a FTD image on the Cisco ASA 5506-X K9 and now I have forgotten the admin password, therefore I can not log into the system at all. I have done all these just for exercises. could anyone help me please?thank you guys.
hello guys, i am totally new in networking and I bought a Cisco ASA 5505 just for some exercises. i can access the devices over putty but cant connect with asdm. I don't know, which ip add should i give to ASDM launcher, but each ip add, which i give...
thanks a lot for your reply!it looks good, but I couldn't find this symbol, which I can put the ip add inside. mdb.sfsnort> delete from EM_peers where name = '172.16.1.240'; I wanted to connect the ssh with my Mac, but I couldn't find any Cisco docu...
