Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am having a problem booting the 7200 automatically.I set the boot system to slot0:filename and when the system reboot it hangs at where the console screen said C7200 platfrom with ..of main memory.It will boot from the image file when I send a bre...
Here is my ACL list:1. permit ip host 192.168.252.244 192.168.0.0 0.0.255.2552. permit ip 192.168.0.0 0.0.255.255 host 192.168.252.244Based on this ACL only host 192.168.252.244 is allow to communicate with other host on 192.168.0.0/16 block but none...
Hi all,I created a private key and generated the certificaterequest. I submitted to CA provider and got back a response. I pem-paste into the SCA and when I loaded the private key and the certificate into ssl server and end. I received a error messag...
Detail of error message:*** Bus Error (Load) Exception ***Access address = 0x3028PC = 0xbfc18a40, Cause = 0x1c, Status Reg = 0x3040d003monitor: command "boot" aborted due to exception
Here it is but I changed the register value to boot to rommon so I could boot to IOS image manually.Thanks,Stevetest_r01#show bootvarBOOT variable = slot0:c7200-k4p-mz.120-17.bin,1;CONFIG_FILE variable =BOOTLDR variable =Configuration register is 0x2...
Bases on your configuration I can do this:Internet | | /28 F/W | Vlan1VPN3020 | /27-------- Vlan2 | |web DBBoth blocks are public IP addresses. Vlan1 and Vlan2 are in the same /27 subnet. Can it be done this way?It is easier if...
