Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have configured radius authenication and have 2 types of users - 15 - all access and 2 limited access. The problem I am experiencing is controlling enable mode access.If the radius server stops then the default username Test1 is used and although I...
I have 2 PIX 515E in HA. Lan based failover and stateful failover configured. If I start FTP from outside to inside and just login to the ftp server and do not do a transfer, fail a pix and there is a pause (47sec) while the secondary pix takes over ...
I have 2 PIX 515E in HA. Lan based failover and stateful failover configured. If I start FTP from outside to inside and just login to the ftp server and do not do a transfer, fail a pix and there is a pause (47sec) while the secondary pix takes over ...
We have an internet connection to 2 different ISP's and use HSRP to track the interface to each ISP. If an interface fails it changes to the other router. What we found on one link (which is a LES100) the link may fail between NTU's but the NTU will ...
The default holddown is 45 seconds. I tested at 20 seconds and the same thing occurred. Dropped it to 6 seconds and it the ftp transfer worked ok. So must be the DOS ftp client droping the transfer when traffic stops for more than 15 sec.
Yes but how would that work when you have 2 ISP's and 2 screen routers. If a ISP fails then screen router still learns the internet routes via iBGP from the other screen router. So if you track a route it still stays in the routing table.
